User's Manual
Table Of Contents
- 1 Getting to know your ADSL modem router
- 2 Getting started
- 3 Configuring the General settings
- 4 Configuring the System settings
- 5 Logout & Reboot
- Appendix A - Firewall
- Appendix B - Pin Assignments
- Appendix C – Specifications
- Appendix D - SSH Client
- Appendix E - Connection Setup
- Appendix F - WPS OPERATION
- Appendix G
132
Appendix E - Connection Setup
Creating a WAN connection is a two-stage process.
1 - Setup a Layer 2 Interface (ATM or Ethernet WAN).
2 - Add a WAN connection to the Layer 2 Interface.
You can reach this page by clicking on the Basic Setup icon
located on the left side of the screen.
The following sections describe each stage in turn.
E1 Layer 2 Interfaces
Every layer2 interface operates in Multi-Service Connection
(VLAN MUX) mode, which supports multiple connections over a
single interface. Note that PPPoA and IPoA connection types are
not supported for Ethernet WAN interfaces. After adding WAN
connections to an interface, you must also create an Interface
Group to connect LAN/WAN interfaces.
E1.1 ATM Interfaces
Follow these procedures to congure an ATM interface.
NOTE: The DSL-N12HP supports up to 16 ATM interfaces.