User's Manual
Table Of Contents
- 1 Getting to know your ADSL modem router
- 2 Getting started
- 3 Configuring the General settings
- 4 Configuring the System settings
- 5 Logout & Reboot
- Appendix A - Firewall
- Appendix B - Pin Assignments
- Appendix C – Specifications
- Appendix D - SSH Client
- Appendix E - Connection Setup
- Appendix F - WPS OPERATION
- Appendix G
7
1.3 Your ADSL modem router
Power LED
O: No power.
Solid green: Device is ready.
Flashing green: Upgrade is in process.
Solid red: POST (Power On Self Test) failure (not bootable) or device
malfunction.
NOTE: A malfunction is any error of internal sequence or state that will
prevent the device from connecting to the DSLAM or passing customer
data. This may be identied at various times such after power on or during
operation through the use of self testing or in operations which result in a
unit state that is not expected or should not occur.
ADSL LED
O: No ADSL link or unable to establish ADSL link.
Solid green: ADSL link is established.
Flashing green: ADSL is attempting to connect to a DSLAM.
Internet LED
O: IP connected and no trac detected (the device has a WAN IP address
from IPCP or DHCP is up or a static IP address is congured, PPP
negotiation has successfully complete.
If the IP or PPPoE session is dropped due to an idle timeout, the light
will remain Blue.
Solid green: Modem power o, modem in bridged mode or WAN
connection not present.
The light will turn o when it attempts to reconnect and
DHCP or PPPoE fails.
Flashing green: IP connected and IP Traffic is passing through the device.
4. 3. 2. 1.
DSL-N12HP 300Mbps
Wi-Fi ADSL Modem Router