- ASUS DVR-104 DVD-R/RW Drive User's Manual

ASUS DVR-104 User’s Manual

Setting the Jumper Terminals

Configure the jumpers to set the device to master or slave mode before

physically installing it to your computer chassis. Use jumper blocks to short

the pins to your desired setting.

Make sure to correctly put the jumper blocks over the pins.

Failure to do so may cause irreparable damage tothe drive!

Master Mode

Cover the two pins labeled MA (see illustration) to set

the DVD-R/RW drive as a secondary master drive.

This is possible only if your computer supports four

IDE devices. The hard disk in the computer is set as

Primary Master.

Slave Mode

Cover the two pins labeled SL (see illustration) to

set the DVD-R/RW drive as a slave device if your

computer supports only two IDE devices.

If your computer supports four IDE devices, this

setting sets your DVD-R/RW drive either as a

Primary Slave or a Secondary Slave.

Cable Select Mode

Cover the two pins labeled CS (see illustration) if your

computer supports a Cable Select (CSEL) signal. You

need an exclusive interface cable for this setting.

Refer to your computer manual for details.

JUMPER

TERMINALS

RESERVED PIN 1

+DVR-104 (09-24).P65 6/20/02, 3:13 PM15