User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 Trusted Computing
- 4.4.2 PCH Storage Configuration
- 4.4.3 Onboard Devices Configuration
- 4.4.4 ACPI Settings
- 4.4.5 APM Configuration
- 4.4.6 SMART Settings
- 4.4.7 NCT6116D Super IO Configuration
- 4.4.8 NCT6116D HW Monitor
- 4.4.9 Serial Port Console Redirection
- 4.4.10 CPU Configuration
- 4.4.11 AMI Graphic Output Protocol Policy
- 4.4.12 PCI Subsystem Settings
- 4.4.13 USB Configuration
- 4.4.14 Network Stack Configuration
- 4.4.15 SDIO Configuration
- 4.4.16 Platform Trust Technology
- 4.4.17 Security Configuration
- 4.4.18 LFP Configuration
- 4.4.19 Thermal
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Appendix
Single Board Computer
79
XHCI Hand-o
NOTE: This item is set to [Disabled] by default for the EHCI (enhanced
host controller interface) support by XHCI drivers in operating systems.
[Disabled] Support XHCI by XHCI drivers for operating systems with XHCI
support.
[Enabled] Support XHCI by BIOS for operating systems without XHCI
support.
USB Mass Storage Driver Support
Allows you to enable or disable the USB Mass Storage driver support.
Conguration options: [Disabled] [Enabled]
USB Port Disable Override
Allows you to selectively enable or disable the corresponding USB port from
reporting a Device connection to the controller.
U3_P1-4
Allows you to enable or disable USB port. Once set to [Disabled], any
USB devices plugged into the connector will not be detected by BIOS
or OS.
Conguration options: [Disabled] [Enabled]
U2_P5-6
Allows y
ou to enable or disable USB port. Once set to [Disabled], any
USB devices plugged into the connector will not be detected by BIOS
or OS.
Conguration options: [Disabled] [Enabled]