User Manual
Table Of Contents
- Notices
- Safety information
- Chapter 1
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 AMT Configuration
- 3.3.7 CSM Configuration
- 3.3.8 Super IO Configuration
- 3.3.9 Serial Console Redirection
- 3.3.10 SATA And RST Configuration
- 3.3.11 Network Stack Configuration
- 3.3.12 USB Configuration
- 3.3.13 NVMe Configuration
- 3.3.14 Onboard Devices Configuration
- 3.3.15 EZ-Flash
- 3.3.16 APM Configuration
- 3.3.17 Watchdog Timer
- 3.3.19 Miscellaneous
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
- BIOS setup
3-20 Chapter 3: BIOS setup
CPU Fan Setting
Temperature 1 ~ Temperature 1
Allows you to set the value of temperature1 / 2 / 3 / 4.
FD/RPM 1 ~ FD/RPM 4
Allows you to set the value of Fan Duty/PRM 1 / 2 / 3 / 4 when temperature is T1 / 2 /
3 / 4.
3.5 Security menu
The Security menu allows a new password to be created or a current password to be
changed. The menu also enables or disables the Secure Boot state and lets the user
congure the System Mode state.
3.5.1 Administrator Password
If you have set an administrator password, we recommend that you enter the administrator
password for accessing the system.
To set an administrator password:
1. Select the Administrator Password item and press <Enter>.
2. From the Create New Password box, key in a password, then press <Enter>.
To change an administrator password:
1. Select the Administrator Password item and press <Enter>.
2. From the Enter Current Password box, key in the current password, then press <Enter>.
3. From the Create New Password box, key in a new password, then press <Enter>.
4. Conrm the password when prompted.
To clear the administrator password, follow the same steps as in changing an administrator
password, but press <Enter> when prompted to create/conrm the password.
3.5.2 User Password
If you have set a user password, you must enter the user password for accessing the system.
To set a user password:
1. Select the User Password item and press <Enter>.
2. From the Create New Password box, key in a password, then press <Enter>.
3. Conrm the password when prompted.