User Manual
Table Of Contents
- Notices
- Safety information
- Chapter 1
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 CSM Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Configuration
- 3.3.9 SATA Configuration
- 3.3.10 USB Configuration
- 3.3.11 Onboard Devices Configuration
- 3.3.12 APM Configuration
- 3.3.13 EzFlash
- 3.3.14 Watchdog Timer
- 3.3.15 Network Stack Configuration
- 3.3.16 Miscellaneous
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
- BIOS setup
Chapter 2: Motherboard information
2-16
NOTE: The serial port cables are purchased separately.
3. COM Port headers (10-pin COM3 - COM8)
These headers are for serial (COM) ports. Connect the serial port cables to these
headers, then install the module to a slot opening at the back of the system chassis.
PIN 1
RXD
DTR#
DSR#
CTS#
DCD#
TXD
GND
RTS#
RI#
PIN 1
COM5 COM6
COM3 COM4
COM7 COM8
CTS#
DSR#
DTR#
RXD
RI#
RTS#
GND
TXD
DCD#
E F
A
A B
C D
E F
B
C D
Connector type
Header 2x5p, K10, 2.54mm pitch
CAUTION! Never connect a 1394 cable to the USB connector. Doing so will damage the
motherboard.
NOTE: The USB cable is purchased separately.
4. USB 2.0 headers/connectors (10-pin USB56, USB78 / USB9, USB10)
These connectors are for USB 2.0 ports. Connect the USB cables to the connectors.
The USB connector complies with USB 2.0 specication that supports up to 480 Mbps
connection speed.
USB56
PIN 1
USB+5V
USB_P5-
USB_P5+
GND
NC
USB+5V
USB_P6-
USB_P6+
GND
C
C D
USB78
USB9 USB10
PIN 1
USB+5V
USB_P7-
USB_P7+
GND
NC
USB+5V
USB_P8-
USB_P8+
GND
D
A B
A B
Connector type
Header 2x5p, K9, 2.54mm pitch