User Manual
Table Of Contents
- Notices
- Safety information
- Chapter 1
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 CSM Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 USB Configuration
- 3.3.12 NVMe Configuration
- 3.3.13 Onboard Devices Configuration
- 3.3.14 Miscellaneous
- 3.3.15 APM Configuration
- 3.3.16 EzFlash
- 3.3.17 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
- BIOS setup
3-5
Chapter 3: BIOS setup
Intel(R) SpeedStep(tm)
This item allows your system to support more than two frequency ranges.
Conguration options: [Disabled] [Enabled]
Intel(R) Speed Shift Technology
This item allows you to enable or disable Intel(R) Speed Shift Technology support.
When enabled, CPPC v2 interface allows hardware controlled P-state. Conguration
options: [Disabled] [Enabled]
Turbo Mode
This item allows you to enable or disable Turbo Mode for your processor. Conguration
options: [Enabled] [Disabled]
CPU C states
[Enabled] Enables the CPU C states.
[Disabled] Disables the CPU C states.
Enhanced C-states
[Disabled] Disables enhanced C1 state.
[Enabled] Enables enhanced C1 state.
Power Limit 1 Override
[Disabled] Disables power limit 1.
[Enabled] Enables power limit 1.
Power Limit 2 Override
[Disabled] Disables power limit 2.
[Enabled] Enables power limit 2.
Power Limit 2
This item allows you to input the value of power limit 2 in milliwatts. If the value is
0, BIOS will program this value as 1.25 times of Processor Base Power (TDP). For
12.50W, enter 12500. Processor applies control policies so that the package power
does not exceed this limit.
3.3.4 Graphics Configuration
Allows you to select a primary display from IGFX, PEG and PCI graphical devices.
Primary Display
Allows you to select which of the IGFX/PEG/PCI Graphics device should be the Primary
Display. Conguration options: [Auto] [IGFX] [PEG Slot] [PCH PCI]
Internal Graphics
[Auto] Keep IGFX enabled base on the setup options.
[Disabled] Disables internal graphics.
[Enabled] Enables internal graphics.
RC6 (Render Standby)
Allows you to enable or disable render standby support. Conguration options: [Disabled]
[Enabled]