User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Super IO Configuration
- 4.4.7 Serial Console Redirection
- 4.4.8 SATA Configuration
- 4.4.9 Network Stack Configuration
- 4.4.10 USB Configuration
- 4.4.11 NVMe Configuration
- 4.4.12 SDIO Configuration
- 4.4.13 Onboard Devices Configuration
- 4.4.14 APM Configuration
- 4.4.15 EZ-Flash
- 4.4.16 Watchdog Timer
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 Updating your BIOS
- Appendix
18
Single Board Computer
2.4 Internal connectors
1. M.2 (E-key) slot
The M.2 (E-key) slot allows you to install an E-key, type 2230 M.2 Wi-Fi
module.
NOTE:
• The M.2 SSD module is purchased separately.
• We recommend using a PH1 screwdriver with a torque of
2.0±0.2kgf-cm when tightening the screw.
2. I2C connector
The I2C (Inter-Integrated Circuit) connector allows you to connect an
I2C-compatible IoT security module.
Connector type
Header 1x4p, K6, 1.0mm pitch