User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Super IO Configuration
- 4.4.7 Serial Console Redirection
- 4.4.8 SATA Configuration
- 4.4.9 Network Stack Configuration
- 4.4.10 USB Configuration
- 4.4.11 NVMe Configuration
- 4.4.12 SDIO Configuration
- 4.4.13 Onboard Devices Configuration
- 4.4.14 APM Configuration
- 4.4.15 EZ-Flash
- 4.4.16 Watchdog Timer
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 Updating your BIOS
- Appendix
Single Board Computer
41
4.4.1 LVDS Conguration
Switch to LVDS
Allows you to enable or disable Switch to LVDS.
Conguration options: [Disable] [Enable]
NOTE: The following items appear only when you set Switch to LVDS
to [Enabled].
All-in-One Chassis
Allows you to select All-in-One (AiO) chassis (if applicable) for simplied AiO
conguration.
Conguration options: [None] [1920*1080 LVDS1] [1920*1080 LVDS2]
[1920*1080 LVDS3] [1600*900 L
VDS4]
NOTE: Be cautious when selecting AiO chassis. Incorrect selection of
AiO chassis can cause incorrect operation or potential damage to AiO
chassis hardware.
Min Backlight
Allows you to set the minimum backlight brightness for the LVDS panel.
Conguration options: [10] [20] [30] [40] [50]
Max Backlight
Allows you to set the maximum brightness for the LVDS panel.
Conguration options: [60] [70] [80] [90] [100]
NOTE: The following items appear only when you set All-in-One
Chassis to [None].