User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Super IO Configuration
- 4.4.7 Serial Console Redirection
- 4.4.8 SATA Configuration
- 4.4.9 Network Stack Configuration
- 4.4.10 USB Configuration
- 4.4.11 NVMe Configuration
- 4.4.12 SDIO Configuration
- 4.4.13 Onboard Devices Configuration
- 4.4.14 APM Configuration
- 4.4.15 EZ-Flash
- 4.4.16 Watchdog Timer
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 Updating your BIOS
- Appendix
54
Single Board Computer
SATA Controller(s)
Allows you to enable or disable the SATA Controller.
Conguration options: [Enabled] [Disabled]
NOTE: The following items appear only when SATA Controller(s) is set
to [Enabled].
SATA Mode Selection
Allows you to determine how SATA controller(s) operate.
Conguration options: [AHCI]
M.2 B-Key(SATA)
Allows you to enable or disable the SATA port.
Conguration options: [Disabled] [Enabled]
4.4.8 SATA Conguration
The items in this menu allow you to congure SATA device options.
While entering Setup, the BIOS automatically detects the presence of SATA
devices. The SATA Port items show [Empty] if no SATA device is installed to
the corresponding SATA port.