User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Super IO Configuration
- 4.4.7 Serial Console Redirection
- 4.4.8 SATA Configuration
- 4.4.9 Network Stack Configuration
- 4.4.10 USB Configuration
- 4.4.11 NVMe Configuration
- 4.4.12 SDIO Configuration
- 4.4.13 Onboard Devices Configuration
- 4.4.14 APM Configuration
- 4.4.15 EZ-Flash
- 4.4.16 Watchdog Timer
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 Updating your BIOS
- Appendix
56
Single Board Computer
4.4.10 USB Conguration
NOTE: The USB Devices item shows the auto-detected values. If no
USB device is detected, the item shows None.
XHCI Hand-o
Allows you to enable or disable workaround for OSes without XHCI hand-o
support. The XHCI ownership change should be claimed by XHCI driver.
Conguration options: [Disabled] [Enabled]
NOTE: This item is set to [Disabled] by default for the EHCI (enhanced
host controller interface) support by XHCI drivers in operating systems.
USB Mass Storage Driver Support
Allows you to enable or disable the USB Mass Storage driver support.
Conguration options: [Disabled] [Enabled]