E4052 Quick Use Guide 15G06Q049000
Powering on your Eee PC These are only quick instructions for using your Eee PC. Read the full manual for detailed information. 1. Install the battery pack 2. Connect the AC power adapter 1 3 3. 2 Turn ON the Eee PC Damage may occur if you use a different adapter to power the Eee PC. You may damage both your battery pack(s) and the Eee PC with a faulty AC-DC adapter.
Powering off your Eee PC Do the following instructions to turn down your Eee PC. A. 1. Click the red power switch in the Notification area. 2. 3. Or, click Instant Shutdown from the Settings tab and select Shutdown. Select Shut Down from the dialogue box. Select OK to proceed. 1 2 3 1 B. Or, press the power switch of the Eee PC directly, and follow the previous instructions to shut down your Eee PC.
Launching First Run Wizard For the first time you start your Eee PC, the First Run Wizard will auto-launch and lead you through setting up your preferences and some basic information. Follow the wizard instructions to finish the initiation. 1. Toggle I agree with this license and click Next to continue. 2. Select your keyboard type and click Next to continue. 3. Enter your User Name. Click Next to continue. 4. Follow the on-screen instructions to complete the first run wizard.
Configuring a network connection Wireless network connection 1. Ensure that the wireless LAN function is enabled. Activate the wireless LAN function by pressing + ( + ) before configuring a wireless network connection if needed. 2. Click Wireless Networks from Internet tab. 3. Select the wireless access point you want to connect to from the list and click Connect to build the connection. Ensure that the box before Enable wireless is checked. 4.
Local Area Network Using a dynamic IP: 1. From the Internet tab, select Network to start the configuration. 2. Click Create to create a network connection. 4. Select the hardware that you 5. want to use to make your connection and click Next. 6. Enter a name for this connection and click Next. 7. Click Finish to apply the settings or click Back to make changes. Click the box before Connect automatically at system startup or before the box Start this connection when finished based on your needs. 3.
Point-to-Point Protocol over Ethernet (PPPoE) 1. Repeat the step 1–2 of Using a static IP to start the PPPoE network configuration. 2. Select the type of connection 3. you are using and click Next. Select the hardware that you want to use to make your connection and click Next. 4. Enter your user and password 5. and click Next.. Enter a name for this connection and click Next. 6. Click Finish to apply the settings or click Back to make changes.
Quick Use Guide -
