User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Performance Tuning menu
- 3.5 Advanced menu
- 3.5.1 Trusted Computing
- 3.5.2 PSP Firmware Versions
- 3.5.3 Redfish Host Interface Settings
- 3.5.4 AMD CBS
- 3.5.5 APM Configuration
- 3.5.6 Onboard LAN Configuration
- 3.5.7 Serial Port Console Redirection
- 3.5.8 CPU Configuration
- 3.5.9 PCI Subsystem Settings
- 3.5.10 USB Configuration
- 3.5.11 Network Stack Configuration
- 3.5.12 CSM Configuration
- 3.5.13 NVMe Configuration
- 3.5.14 AMD Mem Configuration Status
- 3.5.15 Third-party UEFI driver configurations
- 3.6 Chipset menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Event Logs menu
- 3.11 Server Mgmt menu
- 3.12 Exit menu
- Chapter 4: Driver Installation
- Appendix
2-5
ASUS ESC N4A-E11
2.3 Expansion slots
The onboard PCIe slots on the motherboard come pre-installed with riser cards that support
up to three (3) x16 slot (x16 Gen4 link) for installing PCIe expansion cards and supports an
OCP 3.0 card using an OCP 3.0 slot baseboard.
Ensure to unplug the power cord before adding or removing expansion cards. Failure to do
so may cause you physical injury and damage motherboard components.
2.3.1 Installing an expansion card to the right riser card
bracket
1. Loosen the thumbscrew on the rear of the system for the right riser card (A), then pull
and lift the riser card bracket out of the system chassis using the plastic tab (B).
The most bottom PCIe slot on both riser cards are disabled. Please do not install expansion
cards to those PCIe slots.