User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Performance Tuning menu
- 3.5 Advanced menu
- 3.5.1 Trusted Computing
- 3.5.2 PSP Firmware Versions
- 3.5.3 Redfish Host Interface Settings
- 3.5.4 AMD CBS
- 3.5.5 APM Configuration
- 3.5.6 Onboard LAN Configuration
- 3.5.7 Serial Port Console Redirection
- 3.5.8 CPU Configuration
- 3.5.9 PCI Subsystem Settings
- 3.5.10 USB Configuration
- 3.5.11 Network Stack Configuration
- 3.5.12 CSM Configuration
- 3.5.13 NVMe Configuration
- 3.5.14 AMD Mem Configuration Status
- 3.5.15 Third-party UEFI driver configurations
- 3.6 Chipset menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Event Logs menu
- 3.11 Server Mgmt menu
- 3.12 Exit menu
- Chapter 4: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-12
2.3.3 Installing an OCP 3.0 slot baseboard and OCP 3.0
card to the PCIe riser card bracket
Install the OCP 3.0 slot baseboard to the
PCIE1
slot on the left PCIe riser card bracket.
1. Loosen the thumbscrew on the rear of the system for the left riser card (A), then pull
and lift the riser card bracket out of the system chassis using the plastic tab (B).
2. Flip the riser card bracket over.
You may disconnect all the cables connected to the riser card if you are having difficulty
flipping the riser card bracket over.
3. Flip the metal bracket lock open.