User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Performance Tuning menu
- 3.5 Advanced menu
- 3.5.1 Trusted Computing
- 3.5.2 PSP Firmware Versions
- 3.5.3 Redfish Host Interface Settings
- 3.5.4 AMD CBS
- 3.5.5 APM Configuration
- 3.5.6 Onboard LAN Configuration
- 3.5.7 Serial Port Console Redirection
- 3.5.8 CPU Configuration
- 3.5.9 PCI Subsystem Settings
- 3.5.10 USB Configuration
- 3.5.11 Network Stack Configuration
- 3.5.12 CSM Configuration
- 3.5.13 NVMe Configuration
- 3.5.14 AMD Mem Configuration Status
- 3.5.15 Third-party UEFI driver configurations
- 3.6 Chipset menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Event Logs menu
- 3.11 Server Mgmt menu
- 3.12 Exit menu
- Chapter 4: Driver Installation
- Appendix
3-29
ASUS ESC N4A-E11
BankGroupSwapAlt [Auto]
Configuration options: [Enabled] [Disabled] [Auto]
The following item appears only when BankGroupSwapAlt is set to [Enabled].
Address Hash Bank 2 ColXor [3F8]
Configuration options: [000] - [FFF]
Address Hash Bank [Auto]
Allows you to enable or disable bank address hashing.
Configuration options: [Enabled] [Disabled] [Auto]
Address Hash CS [Auto]
Allows you to enable or disable CS address hashing.
Configuration options: [Enabled] [Disabled] [Auto]
Address Hash Rm [Auto]
Allows you to enable or disable RM address hashing.
Configuration options: [Enabled] [Disabled] [Auto]
SPD Read Optimization [Auto]
Allows you to enable or disable SPD Read Optimization, if set to [Enabled],
SPD reads are skipped for Reserved fields and most of upper 256 Bytes. If set
to [Disabled], read all 512 SPD Bytes.
Configuration options: [Enabled] [Disabled] [Auto]
NVDIMM
Disable NVDIMM-N Feature [No]
Allows you to disable NVDIMM-N feature for memory margin tool.
Configuration options: [No] [Yes]
Memory MBIST
MBIST Enable [Disabled]
Allows you to enable or disable Memory MBIST.
Configuration options: [Enabled] [Disabled]
The following items appear only when MBIST Enable is set to [Enabled].
MBIST Test Mode [Auto]
Allows you to select the MBIST Test Mode - Interface Mode (Tests Single and
Multiple CS transactions and Basic Connectivity) or Data Eye Mode (Measures
Voltage vs. Timing).
Configuration options: [Interface Mode] [Data Eye Mode] [Both] [Auto]
MBIST Aggressors [Auto]
Allows you to enable or disable Memory Aggressor test.
Configuration options: [Enabled] [Disabled] [Auto]
MBIST Per Bit Slave Die Reporting [Auto]
Reports 2D Data Eye Results in ABL Log for each DQ, Chipselect, and
Channel.
Configuration options: [Enabled] [Disabled] [Auto]