User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Performance Tuning menu
- 3.5 Advanced menu
- 3.5.1 Trusted Computing
- 3.5.2 PSP Firmware Versions
- 3.5.3 Redfish Host Interface Settings
- 3.5.4 AMD CBS
- 3.5.5 APM Configuration
- 3.5.6 Onboard LAN Configuration
- 3.5.7 Serial Port Console Redirection
- 3.5.8 CPU Configuration
- 3.5.9 PCI Subsystem Settings
- 3.5.10 USB Configuration
- 3.5.11 Network Stack Configuration
- 3.5.12 CSM Configuration
- 3.5.13 NVMe Configuration
- 3.5.14 AMD Mem Configuration Status
- 3.5.15 Third-party UEFI driver configurations
- 3.6 Chipset menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Event Logs menu
- 3.11 Server Mgmt menu
- 3.12 Exit menu
- Chapter 4: Driver Installation
- Appendix
3-41
ASUS ESC N4A-E11
USB Configuration Options
XHCI Controller0 enable [Auto]
Allows you to enable or disable USB3 controller.
Configuration options: [Enabled] [Disabled] [Auto]
XHCI Controller1 enable [Auto]
Allows you to enable or disable USB3 controller.
Configuration options: [Enabled] [Disabled] [Auto]
USB ecc SMI Enable [Auto]
Configuration options: [Enable] [Off] [Auto]
MCM USB enable
XHCI2 enable (Socket1) [Auto]
Allows you to enable or disable USB3 controller.
Configuration options: [Disabled] [Enabled] [Auto]
XHCI3 enable (Socket1) [Auto]
Allows you to enable or disable USB3 controller.
Configuration options: [Disabled] [Enabled] [Auto]
SD Dump Options
SD Configuration Mode [SD Dump disabled]
Configuration options: [SD Dump disabled] [SD Dump enabled]
Ac Power Loss Options
AC Loss Control [Always On]
Allows you to select Ac Loss Control Method.
Configuration options: [Always Off] [Always On] [Reserved] [Previous] [Auto]
I2C Configuration Options
I2C 0 Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
I2C 1 Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
I2C 2 Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
I2C 3 Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
I2C 4 Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
I2C 5 Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Uart Configuration Options
Uart 0 Enable [Auto]
Uart 0 has no HW FC is Uart 2 is enabled.
Configuration options: [Disabled] [Enabled] [Auto]