User Manual

3-42
Chapter 3: BIOS Setup
The following item appears only when Uart 0 Enable is set to [Enabled].
Uart 0 Legacy Options [Auto]
Configuration options: [Disabled] [0x2E8] [0x2F8] [0x3E8] [0x3F8] [Auto]
Uart 1 Enable [Auto]
Uart 1 has no HW FC is Uart 3 is enabled.
Configuration options: [Disabled] [Enabled] [Auto]
The following item appears only when Uart 1 Enable is set to [Enabled].
Uart 1 Legacy Options [Auto]
Configuration options: [Disabled] [0x2E8] [0x2F8] [0x3E8] [0x3F8] [Auto]
Uart 2 Enable (no HW FC) [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
The following item appears only when Uart 2 Enable (no HW FC) is set to [Enabled].
Uart 2 Legacy Options [Auto]
Configuration options: [Disabled] [0x2E8] [0x2F8] [0x3E8] [0x3F8] [Auto]
Uart 3 Enable (no HW FC) [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
The following item appears only when Uart 3 Enable (no HW FC) is set to [Enabled].
Uart 3 Legacy Options [Auto]
Configuration options: [Disabled] [0x2E8] [0x2F8] [0x3E8] [0x3F8] [Auto]
FCH RAS Options
ALink RAS Support [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Reset after sync flood [Auto]
Enable AB to forward downstream sync-flood message to system controller.
Configuration options: [Disabled] [Enabled] [Auto]
Miscellaneous Options
Boot Timer Enable [Auto]
[Disabled] Force PMx44 bit 27 = 1.
[Enabled] Force PMx44 bit 27 = 0.
[Auto] PMx44 bit 27 = PcdBootTimerEnable.
NTB Common Options
Socket-0 P0 NTB Enable [Auto]
Allows you to enable NTB on Socket-0 P0 Link.
Configuration options: [Auto] [Enable]