User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Performance Tuning menu
- 3.5 Advanced menu
- 3.5.1 Trusted Computing
- 3.5.2 PSP Firmware Versions
- 3.5.3 Redfish Host Interface Settings
- 3.5.4 AMD CBS
- 3.5.5 APM Configuration
- 3.5.6 Onboard LAN Configuration
- 3.5.7 Serial Port Console Redirection
- 3.5.8 CPU Configuration
- 3.5.9 PCI Subsystem Settings
- 3.5.10 USB Configuration
- 3.5.11 Network Stack Configuration
- 3.5.12 CSM Configuration
- 3.5.13 NVMe Configuration
- 3.5.14 AMD Mem Configuration Status
- 3.5.15 Third-party UEFI driver configurations
- 3.6 Chipset menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Event Logs menu
- 3.11 Server Mgmt menu
- 3.12 Exit menu
- Chapter 4: Driver Installation
- Appendix
3-56
Chapter 3: BIOS Setup
3.6 Chipset menu
The Chipset menu items allow you to change the Chipset settings.
PCIe Link Training Type [1 Step]
Allows you to select PCIe Link Training in 1 or 2 steps.
Configuration options: [1 Step] [2 Step]
PCIe Compliance Mode [Off]
Allows you to turn the PCIe Compliance Mode on or off.
South Bridge
SB Debug Configuration
SB SATA DEBUG Configuration
The items in this submenu contains options for SATA DEBUG Configuration.
Aggressive Link PM Capability [Enabled]
Indicates whether Host Bus Adapter (HBA) can support Auto-generating
Link Requests to the partial or slumber states when there are no
commands to process.
Configuration options: [Disabled] [Enabled]
Port Multiplier Capability [Enabled]
Indicates whether Host Bus Adapter (HBA) can support a port multiplier.
Configuration options: [Disabled] [Enabled]
SATA Ports Auto Clock Control [Enabled]
Allows you to enable or disable SATA Ports Auto Clock Control.
Configuration options: [Disabled] [Enabled]