User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.2 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 AMD CBS
- 4.5.5 APM Configuration
- 5.5.6 Onboard LAN Configuration
- 4.5.7 Serial Port Console Redirection
- 4.5.8 CPU Configuration
- 4.5.9 PCI Subsystem Settings
- 4.5.10 USB Configuration
- 4.5.11 Network Stack Configuration
- 4.5.12 CSM Configuration
- 4.5.13 NVMe Configuration
- 4.5.14 AMD Mem Configuration Status
- 4.5.15 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-67
ASUS ESC N4A-E11
Configure IPV4 support
DM_LAN1 / Shared LAN
Configuration Address source [Previous State]
Allows you to configure LAN channel parameters statistically or dynamically (by BIOS or
BMC). [Previous State] option will not modify any BMC network parameters during BIOS
phase.
Configuration options: [Previous State] [Static] [DynamicBmcDhcp]
The following items are available only when Configuration Address source is set to
[Static].
Station IP address
Allows you to set the station IP address.
Subnet mask
Allows you to set the subnet mask. We recommend that you use the same Subnet Mask you
have specified on the operating system network for the used network card.
Router IP address
Allows you to set the router IP address.
Router MAC address
Allows you to set the router MAC address.
Configure IPV6 support
DM_LAN1
IPV6 Support [Enabled]
Allows you to enable or disable LAN1 IPV6 Support.
Configuration options: [Disabled] [Enabled]
The following item appears only when IPV6 Support is set to [Enabled].
Configuration Address source [Previous State]
Allows you to configure LAN channel parameters statistically or dynamically (by BIOS or
BMC). [Previous State] option will not modify any BMC network parameters during BIOS
phase.
Configuration options: [Previous State] [Static] [DynamicBmcDhcp]
The following items are available only when Configuration Address source is set to
[Static].
Station IPV6 address
Allows you to set the station IPV6 address.
Prefix Length
Allows you to set the prefix length (maximum of Prefix Length is 128).