User Manual

Chapter 2: Hardware Setup
2-4
4. Push the drive tray and storage device
assembly all the way into the depth of
the bay until the tray lever and spring
lock clicks and secures the drive tray in
place.
• When installed, the SATA/SAS/NVMe connector on the drive connects to the SATA/
SAS/NVMe interface on the backplane.
• The drive tray is correctly placed when its front edge aligns with the bay edge.
5. Repeat steps 1 to 4 to install the other 3.5-inch storage devices.
3. Please follow step 4 of the
Installing a 3.5-inch storage device
section to Replace
the drive tray.
4. Repeat steps 1 to 3 to install the other 2.5-inch storage devices.
2.2.2 Installing a 2.5-inch storage device
1. Please follow steps 1 and 2 of the
Installing a 3.5-inch storage device
section to
remove the drive tray.
HDD1
2. Place the 2.5-inch storage device into
the tray (A) then secure it with four
screws (B).
Ensure to take note of the tool-less
notch as it may interfere when trying
to align the screw holes. Press the
storage device down on the notch if
you are experiencing issues trying to
align the screw holes.