User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.2 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 AMD CBS
- 4.5.5 APM Configuration
- 5.5.6 Onboard LAN Configuration
- 4.5.7 Serial Port Console Redirection
- 4.5.8 CPU Configuration
- 4.5.9 PCI Subsystem Settings
- 4.5.10 USB Configuration
- 4.5.11 Network Stack Configuration
- 4.5.12 CSM Configuration
- 4.5.13 NVMe Configuration
- 4.5.14 AMD Mem Configuration Status
- 4.5.15 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-13
ASUS ESC N4A-E11
CPU Common Options
Performance
OC Mode [Normal Operation]
Configuration options: [Normal Operation] [Customized]
The following items appear only when OC Mode is set to [Customized].
Custom Core Pstates
Allows you to enable Core Pstates. Read the disclaimer and select I Accept to
continue.
Damage caused by use of your AMD processor outside of specification or in excess of
factory settings are not covered by your system manufacturers warranty.
The following items appear only when [Accept] is selected for Custom Core Pstates.
Custom Pstate0 [Auto]
Configuration options: [Auto] [Custom]
The following items appear only when Custom Pstate0 is set to [Custom].
Pstate0 Freq (MHz) [0]
Allows you to specify core frequency (MHz).
CCD/Core/Thread Enablement
This option allows you to enable CCD/Core/Thread Enablement.
S3 is not supported on systems where cores/threads have been removed/disabled.
CCD Control [Auto]
Sets the number of CCDs to be used. Once this option has been used
to remove any CCDs, a POWER CYCLE is required in order for future
selections to take effect.
Configuration options: [Auto] [2 CCDs] [3 CCDs] [4 CCDs] [6 CCDs]
Core Control [Auto]
Sets the number of cores to be used. Once this option has been used
to remove any cores, a POWER CYCLE is required in order for future
selections to take effect.
Configuration options: [Auto] [ONE (1 + 0)] [TWO (2 + 0)] [THREE (3 +
0)] [FOUR (4 + 0)] [FIVE (5 + 0)] [SIX (6 + 0)] [SEVEN (7 + 0)]
SMT Control [Auto]
Can be used to disable symmetric multithreading. To re-enable SMT, a
POWER CYCLE is needed after selecting the [Enable] option. Select [Auto]
based on BIOS PCD (PcdAmdSmtMode) defatul setting.
Configuration options: [Disable] [Enable] [Auto]
S3 is not supported on systems where cores/threads have been removed/disabled.