User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.2 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 AMD CBS
- 4.5.5 APM Configuration
- 5.5.6 Onboard LAN Configuration
- 4.5.7 Serial Port Console Redirection
- 4.5.8 CPU Configuration
- 4.5.9 PCI Subsystem Settings
- 4.5.10 USB Configuration
- 4.5.11 Network Stack Configuration
- 4.5.12 CSM Configuration
- 4.5.13 NVMe Configuration
- 4.5.14 AMD Mem Configuration Status
- 4.5.15 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-29
ASUS ESC N4A-E11
Data Eye
Pattern Select [PRBS]
Configuration options: [PRBS] [SS0] [Both]
Pattern Length [3]
This token helps to determine the pattern length. The possible options
are N=3...12.
Configuration options: [3] – [9]
Aggressor Channel [1 Aggressor Channel]
This helps read the aggressors channels. If set to [Enabled], you can
read from one or more than one aggressor channel. The default is set
to [Disabled].
Configuration options: [Disabled] [1 Aggressor Channel] [3 Aggressor
Channels] [7 Aggressor Channels]
Aggressor Static Lane Control [Disabled]
Configuration options: [Disabled] [Enabled]
The following items appear only when Aggressor Static Lane Control is set to [Enabled].
Aggressor Static Lane Select Upper 32 bits [0]
Static Lane Select for Upper 32 bits. The bit mask represents the bits to
be read.
Configuration options: [0] - [99999999]
Aggressor Static Lane Select Lower 32 bits [0]
Static Lane Select for Lower 32 bits. The bit mask represents the bits to
be read.
Configuration options: [0] - [99999999]
Aggressor Static Lane Select ECC [0]
Static Lane Select for ECC Lanes. The bit mask represents the bits to
be read.
Configuration options: [0] - [9]
Aggressor Static Lane Value [0]
Configuration options: [0] - [9]
Target Static Lane Control [Disabled]
Configuration options: [Disabled] [Enabled]
The following items appear only when Target Static Lane Control is set to [Enabled].
Target Static Lane Select Upper 32 bits [0]
Static Lane Select for Upper 32 bits. The bit mask represents the bits to
be read.
Configuration options: [0] - [99999999]
Target Static Lane Select Lower 32 bits [0]
Static Lane Select for Lower 32 bits. The bit mask represents the bits to
be read.
Configuration options: [0] - [99999999]
Target Static Lane Select ECC [0]
Static Lane Select for ECC Lanes. The bit mask represents the bits to
be read.
Configuration options: [0] - [9]