User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.2 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 AMD CBS
- 4.5.5 APM Configuration
- 5.5.6 Onboard LAN Configuration
- 4.5.7 Serial Port Console Redirection
- 4.5.8 CPU Configuration
- 4.5.9 PCI Subsystem Settings
- 4.5.10 USB Configuration
- 4.5.11 Network Stack Configuration
- 4.5.12 CSM Configuration
- 4.5.13 NVMe Configuration
- 4.5.14 AMD Mem Configuration Status
- 4.5.15 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-37
ASUS ESC N4A-E11
Presence Detect Select mode [Auto]
Allows you to control the Presence Detect Select mode.
Configuration options: [OR] [AND] [Auto]
Preferred IO [Auto]
Allows you to select the preferred IO select type.
Configuration options: [Bus] [Auto]
Data Link Feature Cap [Auto]
Allows you to set Data Link Feature Capability.
Configuration options: [Enabled] [Disabled] [Auto]]
CV test [Auto]
Set this to [Enabled] to support running PCIECV tool. Selecting [Auto] will preserve h/w
defaults.
Configuration options: [Auto] [Disabled] [Enabled]
SEV-SNP Support [Disable]
Configuration options: [Disabled] [Enabled]
SRIS [Auto]
Configuration options: [Auto] [Disable] [Enable]
FCH Common Options
SATA Configuration Optoins
SATA Enable [Auto]
Allows you to enable or disable OnChip SATA controller.
Configuration options: [Disabled] [Enabled] [Auto]
The following item appears only when SATA Enable is set to [Enabled].
SATA Mode [AHCI]
Allows you to select the OnChip SATA Type.
Configuration options: [AHCI] [AHCI as ID 0x7904] [Auto]
Sata RAS Support [Auto]
Allows you to enable or disable Sata RAS Support.
Configuration options: [Disabled] [Enabled] [Auto]
Sata Disabled AHCI Prefetch Function [Auto]
Allows you to enable or disable Sata Disabled AHCI Prefetch Function.
Configuration options: [Disabled] [Enabled] [Auto]
Aggressive SATA Device Sleep Port 0 [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
The following item appears only when Aggressive SATA Device Sleep Port 0 is set to
[Enabled].
DevSleep0 Port Number [0]
Allows you to set the DEVSLP port 0.
Configuration options: [0] - [7]