User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 UEFI Variables Protection
- 4.5.6 Serial Port Console Redirection
- 4.5.7 CPU Configuration
- 4.5.8 PCI Subsystem Settings
- 4.5.9 USB Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 SATA Configuration
- 4.5.13 APM Configuration
- 4.5.14 AMD Mem Configuration Status
- 4.5.15 T1s Auth Configuration
- 4.5.16 Third-party UEFI driver configurations
- 4.5.17 Driver Health
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Appendix
2-23
2.6.2 Installing an expansion card to the lower PCIe
expansion card brackets
The server system comes pre-installed with two lower PCIe expansion card brackets that
support two x16 slots (Gen5 x16 link) for installing half-height, half-length PCIe expansion
cards and one x8 slot (Gen4 x8 link) for installing a RAID card.
The PCIe x8 slot may be unavailable on certain models.
To install a PCIe expansion card to the lower right PCIe expansion card bracket:
1. Remove the server tray from the server chassis. For more information, see the
Removing the server tray
section.
2. Remove the upper PCIe expansion card brackets from the server tray. For more
information, see the
Removing the upper PCIe expansion card brackets
section.
3. Remove the lower PCIe expansion card brackets from the server tray. For more
information, see the
Removing the lower PCIe expansion card brackets
section.
Lower right PCIe expansion card bracket