User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- 2.1 Chassis cover
- 2.2 Central Processing Unit (CPU)
- 2.3 System memory
- 2.4 Storage devices
- 2.5 Expansion slots
- 2.5.1 The PCI Express riser card
- 2.5.2 Installing an ASUS PIKE II card
- 2.5.3 Reconnecting the cable to the M.2 expansion board (only for SKU-3)
- 2.5.4 Installing an M.2 (NGFF) card
- 2.5.5 Reconnecting the cable to the OCP 3.0 slot baseboard (only for SKU-2)
- 2.5.6 (optional) Installing the PFR module
- 2.5.7 Configuring an expansion card
- 2.6 Cable connections
- 2.7 SATA/SAS backplane cabling
- 2.8 Removable/optional components
- 2.9 Rail Kit Options
- Chapter 3: Motherboard Infomation
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 OffBoard SATA Controller Configuration
- 4.4.2 Trusted Computing
- 4.4.3 ACPI Settings
- 4.4.4 Redfish Host Interface Settings
- 4.4.5 Onboard LAN Configuration
- 4.4.6 Serial Port Console Redirection
- 4.4.7 SIO Common Setting
- 4.4.8 SIO Configuration
- 4.4.9 PCI Subsystem Settings
- 4.4.10 USB Configuration
- 4.4.11 Network Stack Configuration
- 4.4.12 CSM (Compatibility Support Module)
- 4.4.13 NVMe Configuration
- 4.4.14 APM Configuration
- 4.4.15 Third-party UEFI driver configurations
- 4.5 Platform Configuration menu
- 4.6 Socket Configuration menu
- 4.7 Event Logs menu
- 4.8 Server Mgmt menu
- 4.9 Security menu
- 4.10 Boot menu
- 4.11 Tool menu
- 4.12 Save & Exit menu
- Chapter 5: Driver Installation
- Appendix
4-60
Chapter 4: BIOS Setup
OS Wtd Timer Policy [Reset]
This item allows you to configure the how the system should respond if the OS Boot
Watch Timer expires. Not available if OS Boot Watchdog Timer is disabled.
Configuration options: [Do Nothing] [Reset] [Power Down] [Power Cycle]
4.8.1 System Event Log
Allows you to change the SEL event log configuration.
All values changed here do not take effect until computer is restarted.
SEL Components [Enabled]
Allows you to enable or disable event logging for error/progress codes during boot.
Configuration options: [Disabled] [Enabled]
The following item is available only when
SEL Components
is set to
[Enabled]
.
Erase SEL [No]
Allows you to choose options for erasing SEL.
Configuration options: [No] [Yes, On next reset] [Yes, On every reset]
4.8.2 BMC self test log
Logs the report returned by BMC self test command.
Erase Log [Yes, On every reset]
Allows you to choose options for erasing log.
Configuration options: [Yes, On every reset] [No]