User Manual

Chapter 2: Hardware setup2-12
2.5 Expansion slot
2.5.1 Installing an expansion card to the riser card bracket
The barebone server comes with a riser card bracket. You need to remove the
bracket if you want to install PCI Express x16 expansion cards.
To install a PCI Express x16 card
4. Press the riser card bracket until
the golden connectors completely
t the slot and the bracket aligns
with the rear panel.
5. Connect the cable(s) to the card, if
applicable.
3. Install a PCI Express x16 card to
the bracket as shown, and then
secure the card with a screw.
1. Firmly hold the riser card bracket,
and then pull it up to detach it from
the PCI Express x16 slot on the
motherboard.
2. Place the riser card bracket on a
at and stable surface, and then
remove the screw from the slot bay.
PCI Express x16 slot