User Manual

Chapter 2: Hardware setup2-22
5. Carefully cut the cable tie on the
SATA/SAS cables and SGPIO
cables.
6. Connect the SGPIO2 cable (with
a green label) to the SGPIO1
connector and the SGPIO3 cable
(without a label) to the SGPIO2
connector on the PIKE riser card.
7. Remove the SATA/SAS cables from
the onboard SATA1–4 connectors.
8. The SATA/SAS cables are tied and
labeled in four groups. Group 1
connects to HDD 1 and 2, Group 2
to HDD 3 and 4, Group 3 to HDD 5
and 6, and Group 4 to HDD 7 and 8.