User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 Trusted Computing
- 5.5.2 PSP Firmware Versions
- 5.5.3 APM Configuration
- 5.5.4 Onboard LAN Configuration
- 5.5.5 Serial Port Console Redirection
- 5.5.6 CPU Configuration
- 5.5.7 PCI Subsystem Settings
- 5.5.8 USB Configuration
- 5.5.9 Network Stack Configuration
- 5.5.10 CSM Configuration
- 5.5.11 NVMe Configuration
- 5.5.12 SATA Configuration
- 5.5.13 AMD Mem Configuration Status
- 5.6 Chipset menu
- 5.7 Security menu
- 5.8 Boot menu
- 5.9 Tool menu
- 5.10 Event Logs menu
- 5.11 Server Mgmt menu
- 5.12 Exit menu
- Chapter 6: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-34
2.8.4 U.2 drives
1
2
Storage device bay 3 and 4
To install a U.2 drive:
1. Install the U.2 drive to storage device bay 3 or 4.
Refer to section
2.4.2 Installing the 2.5-inch SSD
for the steps on installing a 2.5-inch
drive to the HDD bay.
2. Remove the slimline SAS cables from the internal SAS/HBA/Storage bracket.
For the ESC4000A-E11, additional U.2 drives may be installed in storage device bays 3 and
4 as shown in the illustration below: