User Manual

Chapter 2: Hardware Setup
2-12
1. Remove the drive tray.
Refer to section
2.4.1 Installing the 3.5-inch SATA HDD/SAS HDD
for the steps on
removing the drive tray.
4. Replace the drive tray.
Refer to section
2.4.1 Installing the 3.5-inch SATA HDD/SAS HDD
for the steps on
replacing the drive tray.
2. Prepare the SSD/SATA HDD/SAS HDD/
NVMe and the bundled set of screws.
3. Place the SSD/SATA HDD/SAS HDD/
NVMe into the tray (A) then secure it
with four screws (B).
Ensure to take note of the tool-less
notch as it may interfere when trying to
align the screw holes. Press the SSD/
SATA HDD/SAS HDD/NVMe down
on the notch if you are experiencing
issues trying to align the screw holes.
2.4.2 Installing the 2.5-inch SSD/SATA HDD/SAS HDD/NVMe
1
2
Storage device bay 1 and 2
(default NVMe)
Storage device bay 3 and 4
The NVMe drives may be installed in storage device bays 1, 2, 3, and 4 as shown in the
illustration below:
• The default storage device bays to install NVMe drives are storage device bays 1 and 2.
• Support for NVMe drives for storage device bays 3 and 4 is optional, please refer to
section
2.8.4 U.2 drives (optional)
before installing a NVMe drive to storage device
bays 3 and 4.
5. Repeat steps 1 to 4 to install additional SSD/SATA HDD/SAS HDD/NVMe.