User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: Motherboard Infomation
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 Trusted Computing
- 5.5.2 PSP Firmware Versions
- 5.5.3 APM Configuration
- 5.5.4 Onboard LAN Configuration
- 5.5.5 Serial Port Console Redirection
- 5.5.6 CPU Configuration
- 5.5.7 PCI Subsystem Settings
- 5.5.8 USB Configuration
- 5.5.9 Network Stack Configuration
- 5.5.10 CSM Configuration
- 5.5.11 NVMe Configuration
- 5.5.12 SATA Configuration
- 5.5.13 AMD Mem Configuration Status
- 5.6 Chipset menu
- 5.7 Security menu
- 5.8 Boot menu
- 5.9 Tool menu
- 5.10 Event Logs menu
- 5.11 Server Mgmt menu
- 5.12 Exit menu
- Chapter 6: Driver Installation
- Appendix
2-25
ASUS ESC4000A-E11
2.5.5 Reconnecting the cable to the OCP3.0 slot baseboard
You may reconnect the cables to enable the OCP3.0 slot baseboard located in the front of
the system.
The cables are connected by default if your system package comes with the OCP3.0 slot
baseboard pre-installed.
1. (optoinal) Remove the two (2) slimline SAS cables from the internal riser board for
PCIe slot, if your system comes with the slimline SAS cables connected.
2. Connect two (2) slimline SAS cables to the two connectors to the left on your OCP3.0
slot baseboard.
1
2