User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 AMD CBS
- 4.5.3 Onboard LAN Configuration
- 4.5.4 Serial Port Console Redirection
- 4.5.5 CPU Configuration
- 4.5.6 PCI Subsystem Settings
- 4.5.7 USB Configuration
- 4.5.8 Network Stack Configuration
- 4.5.9 NVMe Configuration
- 4.5.10 SATA Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Driver Health
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
2-13
ASUS ESC4000A-E12
4. Push the storage device and drive tray
assembly all the way into the the drive
bay until the tray lever and spring lock
clicks and secures the drive tray in
place.
• When installed, the SATA/SAS connector on the drive connects to the SATA/SAS
interface on the backplane.
• The drive tray is correctly placed when its front edge aligns with the bay edge.
5. Repeat steps 1 to 4 to install additional 3.5” storage devices..
2.4.2 Installing a 2.5-inch SATA/SAS/NVMe storage device.
To install 2.5-inch storage devices into storage bays 1 and 2:
1. Remove the drive tray.
Refer to the
Installing a 3.5-inch SATA/SAS storage device
section for the steps on
removing the drive tray.
2. Push the tool-less 2.5-inch tray through
the openings on the bottom of the drive
tray.
3. Prepare the 2.5-inch storage device,
then place it into the tool-less 2.5-inch
tray.