User Manual
Table Of Contents
- Notices
- Chapter 1: Product Introduction
- Chapter 2: Getting Started
- Chapter 3: Web-based User Interface
- 3.1 Web-based user interface
- 3.2 Dashboard
- 3.3 Sensor
- 3.4 System Inventory
- 3.5 FRU Information
- 3.6 Logs & Reports
- 3.7 Settings
- 3.7.1 Captured BSOD
- 3.7.2 Date & Time
- 3.7.3 External User Services
- 3.7.4 KVM Mouse Setting
- 3.7.5 Log Settings
- 3.7.6 Manage Licenses
- 3.7.7 Media Redirection Settings
- 3.7.8 Network Settings
- 3.7.9 PAM Order Settings
- 3.7.10 Platform Event Filters
- 3.7.11 NIC Management
- 3.7.12 Services
- 3.7.13 SMTP Settings
- 3.7.14 SSL Settings
- 3.7.15 System Firewall
- 3.7.16 User Management
- 3.7.17 Video Recording
- 3.7.18 IPMI Interfaces
- 3.7.19 Fan Control
- 3.7.20 PSU Cold Redundancy
- 3.8 Remote Control
- 3.9 Image Redirection
- 3.10 Power Control
- 3.11 Locator LED
- 3.12 Maintenance
- Appendix
ASUS ASMB11-iKVM
2-3
2.3 Firmware update and IP configuration
Follow the below steps to update the firmware and configure the IP source before using the
ASMB11-iKVM board for the first time.
2.3.1 Updating the firmware on Linux
1. Navigate to the tools folder, then run the update script.
To update the firmware remotely:
./FWUpdate_Linux.sh [IP address] [username] [password] [options]
To update the firmware locally:
./FWUpdate_Linux.sh -local [username] [password] [options]
• Make sure you are connected to the internet.
• Supported options are
-p
to preserve configuration options or
-f
to force boot.
2. If prompted, type Y to perform a full firmware upgrade.
2.3.2 Updating the firmware on Windows
1. Navigate to the tools folder, then run the update script.
To update the firmware remotely:
./FWUpdate_Win.bat [IP address] [username] [password] [options]
To update the firmware locally:
./FWUpdate_Win.bat -local [username] [password] [options]
• Make sure you are connected to the internet.
• Supported options are
-p
to preserve configuration options or
-f
to force boot.
• The AMI driver must be installed for USB-Lan support on Windows
2. If prompted, type Y to perform a full firmware upgrade.