User Guide
Table Of Contents
- Notices
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Installation options
- Chapter 4: Motherboard Info
- Chapter 5: BIOS setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Advanced menu
- 5.4.1 ACPI Settings
- 5.4.2 Smart Settings
- 5.4.3 NCT6779D Super IO Configuration
- 5.4.4 Onboard LAN I210 Configuration
- 5.4.5 Serial Port Console Redirection
- 5.4.6 APM
- 5.4.7 Advanced Power Management Configuration
- 5.4.8 PCI Subsystem Settings
- 5.4.9 Network Stack Configuration
- 5.4.10 CSM Configuration
- 5.4.11 Trusted Computing
- 5.4.12 USB Configuration
- 5.4.13 iSCSI Configuration
- 5.5 IntelRCSetup menu
- 5.5.1 Processor Configuration
- 5.5.2 Advanced Power Management Configuration
- 5.5.3 Common RefCode Configuration
- 5.5.4 QPI Configuration
- 5.5.5 Memory Configuration
- 5.5.6 IIO Configuration
- 5.5.7 PCH Configuration
- 5.5.8 Miscellaneous Configuration
- 5.5.9 Server ME Configuration
- 5.5.10 Runtime Error Logging Support
- 5.6 Server Mgmt menu
- 5.7 Event Logs menu
- 5.8 Monitor menu
- 5.9 Security menu
- 5.10 Boot menu
- 5.11 Tool menu
- 5.12 Exit menu
- Chapter 6: RAID Configuration
- Chapter 7: Driver installation
- 7.1 RAID driver installation
- 7.2 Management applications and utilities installation
- 7.3 Running the Support DVD
- 7.4 Intel® chipset device software installation
- 7.5 Installing the Intel® I210 Gigabit Adapters driver
- 7.6 VGA driver installation
- 7.7 Intel® Rapid Storage Technology enterprise 4.1 installation
- Appendix
2-33
ASUS ESC8000 G3
4. Prepare the PIKE II series card and the mini-SAS HD to mini-SAS cable.
5. Connect the other end of the mini-SAS HD to mini-SAS cable to the connectors on the
PIKE II card.
6. Lay the mini-SAS HD to mini-SAS cable on the system as shown.
• Ensure that the latch of the cable is facing the side of the chassis.
• Leverage the space on the LAN module and arrange the cable under the metal
module.
7. Remove the pre-installed cables connected to the ISAS1 and ISAS2 headers on the
backplane.
8. Connect the connectors of the mini-SAS HD to mini-SAS cable to the ISAS1 and ISAS2
connector on the backplane.
It is recommended that you use a mini-SAS HD to mini-SAS cable with a minimum length of
78 cm to ensure you have adequate length to connect and properly layout the cable inside
the chassis of the server.
Latch of the cable
backplane
mini-SAS HD to mini-SAS cable
ISAS1
ISAS2