User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Ai Tweaker
- 4.5 Performance Tuning menu
- 4.6 Advanced menu
- 4.6.1 Trusted Computing
- 4.6.2 ACPI Settings
- 4.6.3 Smart Settings
- 4.6.4 Super IO Configuration
- 4.6.5 Serial Port Console Redirection
- 4.6.6 Onboard LAN Configuration
- 4.6.7 APM
- 4.6.8 PCI Subsystem Settings
- 4.6.9 USB Configuration
- 4.6.10 CSM Configuration
- 4.6.11 NVMe Configuration
- 4.6.12 Network Stack Configuration
- 4.6.13 iSCSI Configuration
- 4.7 Platform Configuration menu
- 4.8 Socket Configuration menu
- 4.9 Event Logs menu
- 4.10 Server Mgmt menu
- 4.11 Security menu
- 4.12 Boot menu
- 4.13 Tool menu
- 4.14 Save & Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
4-12
Chapter 4: BIOS Setup
CPU1-2 Power Phase Control [Auto]
This item allows you to set the power phase control of the CPU.
[Auto] Automatically set the phase control mode.
[Extreme] Set to the full phase mode.
DO NOT remove the thermal module. The thermal conditions should be monitored.
CPU1-2 Thermal Control [120]
This item allows you to configure the thermal control value. A higher temperature
provides a wider CPU power thermal range and extends the over clocking tolerance to
enlarge the overclocking potential.
DO NOT remove the thermal module. The thermal conditions should be monitored.
DRAM-ABC / DRAM-DEF / DRAM-GHJ / DRAM-KLM Current Capability[100%]
The DRAM current capability adjusts the total power range for DRAM overclocking.
A higher value provides a wider total power range and extends the overclocking
frequency range simultaneously.
Configuration options: [100%] [110%] [120%] [130%] [140%]
DRAM-ABC / DRAM-DEF / DRAM-GHJ / DRAM-KLM Phase Control [100%]
This item allows you to set the power phase control of the DRAM.
[Auto] Automatically set the phase control mode.
[Extreme] Set to the full phase mode.
DO NOT remove the thermal module. The thermal conditions should be monitored.