User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Ai Tweaker
- 4.5 Performance Tuning menu
- 4.6 Advanced menu
- 4.6.1 Trusted Computing
- 4.6.2 ACPI Settings
- 4.6.3 Smart Settings
- 4.6.4 Super IO Configuration
- 4.6.5 Serial Port Console Redirection
- 4.6.6 Onboard LAN Configuration
- 4.6.7 APM
- 4.6.8 PCI Subsystem Settings
- 4.6.9 USB Configuration
- 4.6.10 CSM Configuration
- 4.6.11 NVMe Configuration
- 4.6.12 Network Stack Configuration
- 4.6.13 iSCSI Configuration
- 4.7 Platform Configuration menu
- 4.8 Socket Configuration menu
- 4.9 Event Logs menu
- 4.10 Server Mgmt menu
- 4.11 Security menu
- 4.12 Boot menu
- 4.13 Tool menu
- 4.14 Save & Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
ASUS ESC8000 G4 Series
6-3
5.1.3 Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set from SATA
hard disk drives attached to the SATA connectors supported by Intel
®
C621 chipset.
To do this:
1. Enter the BIOS Setup during POST.
2. Go to the Platform Configuration menu Menu > PCH Configuration Menu > PCH
SATA Configuration, then press <Enter>.
3. Set Configure sSATA as to [RAID Mode]
4. Press <F10> to save your changes and exit the BIOS Setup.
Refer to Chapter 5 for details on entering and navigating through the BIOS Setup.
5.1.4 RAID configuration utilities
Depending on the RAID connectors that you use, you can create a RAID set using the utilities
embedded in each RAID controller. For example, use the Intel
®
Rapid Storage Technology
if you installed Serial ATA hard disk drives on the Serial ATA connectors supported by the
Intel
®
C621 chipset.
Refer to the succeeding section for details on how to use the RAID conguration utility.
5.1.2 Installing hard disk drives
The motherboard supports Serial ATA for RAID set conguration. For optimal performance,
install identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for RAID conguration:
1. Install the SATA hard disks into the drive bays following the instructions in the system
user guide.
2. Connect a SATA signal cable to the signal connector at the back of each drive and to
the SATA connector on the motherboard.
3. Connect a SATA power cable to the power connector on each drive.