User Manual
Table Of Contents
- Contents
- Notices
- Federal Communications Commission Statement
- Canadian Department of Communications Statement
- IC Radiation Exposure Statement for Canada
- Declaration of Conformity (R&TTE directive 1999/5/EC)
- CE Mark Warning
- Wireless Operation Channel for Different Domains
- France Restricted Wireless Frequency Bands
- REACH
- Global Environmental Regulation Compliance and Declaration
- Takeback Services
- UL Safety Precaution
- ENERGY STAR complied product
- Notes for this manual
- Safety information
- Notices
- Welcome
- Getting to know your All-in-one PC
- Positioning your All-in-one PC
- Setting up your All-in-one PC
- Recovering your system
English
28 All-in-one PC ET2011 Series
Positioning your All-in-one PC
Placing on the desktop
Place your All-in-one PC on a flat surface such as a table or desk, and pull the stand open untilpull the stand open until
it snaps in place. Then, tilt the display panel to an angle of between 12 and 27 degrees from an
upright position.
12
O
0
O
27
O
0
O
Mounting to the wall (optional)
To mount your All-in-one PC to the wall, purchase the optional wall mount kit (VESA 75, 75mm
x 75mm or VESA100, 100mm x 100mm). Install the wall mount kit according to the following
instructions.
1. Place your All-in-one PC on a flat surface
such as a table or desk, and then remove
the two screws beside the stand. Keep the
screws for future use in case you want to
reinstall the stand.