User's Manual

1-2
Chapter 1: Product introduction
ATX power connectors (24-pin EATXPWR, 8-pin ATX12V)
CorrectlyorienttheATXpowersupplyplugsintotheseconnectorsandpushdown
rmlyuntiltheconnectorscompletelyt.
• Forafullyconguredsystem,werecommendthatyouuseapowersupply
unit(PSU)thatcomplieswithATX12VSpecication2.0(orlaterversion)
andprovidesaminimumpowerof350W.
• Ifyouareuncertainabouttheminimumpowersupplyrequirementforyour
system,refertotheRecommendedPowerSupplyWattageCalculator
athttp://support.asus.com/PowerSupplyCalculator/PSCalculator.
aspx?SLanguage=en-usfordetails.
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN)
Connectthefancablestothefanconnectorsonthemotherboard,ensuringthatthe
blackwireofeachcablematchesthegroundpinoftheconnector.
Donotforgettoconnectthefancablestothefanconnectors.Insufcientair
owinsidethesystemmaydamagethemotherboardcomponents.Theseare
notjumpers!Donotplacejumpercapsonthefanconnectors!TheCPU_FAN
connectorsupportsaCPUfanofmaximum1A(12W)fanpower.
Serial port connector (10-1 pin COM)
Connecttheserialportmodulecabletothisconnector,theninstallthemoduletoa
slotopeningatthebackofthesystemchassis.
Intel
®
LGA1151 CPU socket
InstallIntel
®
LGA1151CPUintothissurfacemountLGA1151socket,whichis
designedfor6thGenerationIntel
®
Core™i7/i5/i3,Pentium
®
,andCeleron
®

processors.
Formoredetails,refertoCentral Processing Unit (CPU).
M.2 socket 3
ThissocketallowsyoutoinstallanM.2(NGFF)
SSDmodule.
ThissocketsupportsMKeyand2242/2260/2280
storagedevices.
M.2(SOCKET3)
2280 2260 2242
DDR4 DIMM slots
Install2GB,4GB,8GB,and16GBunbufferednon-ECCDDR4DIMMsintothese
DIMMsockets.
Formoredetails,refertoSystem memory.