User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Introduction to the BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Advanced menu
- 4.5.1 Platform Misc Configuration
- 4.5.2 CPU Configuration
- 4.5.3 System Agent (SA) Configuration
- 4.5.4 PCH Configuration
- 4.5.5 PCH Storage Configuration
- 4.5.6 PCH-FW Configuration
- 4.5.7 AMT Configuration
- 4.5.8 Thunderbolt(TM) Configuration
- 4.5.9 Serial Port Console Redirection
- 4.5.10 Intel TXT Information
- 4.5.11 PCI Subsystem Settings
- 4.5.12 USB Configuration
- 4.5.13 Network Stack Configuration
- 4.5.14 NVMe Configuration
- 4.5.15 HDD/SSD SMART Information
- 4.5.16 APM Configuration
- 4.5.17 Onboard Devices Configuration
- 4.5.18 Intel(R) Rapid Storage Technology
- 4.6 Monitor menu
- 4.7 Boot menu
- 4.8 Tool menu
- 4.9 Exit menu
- 4.10 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
2-13
ASUS E500 G9
2.6 5.25-inch drives
Installing a 5.25-inch drive
To install a 5.25-inch drive:
1. Remove the front panel cover. Refer to
the
Removing the front panel cover
section for more information.
2. Pull the bay locks outward.
3. Remove the metal cover of the bay
you intend to use.
Take extra care when removing the
metal cover. Use tools such as a
screw driver to bend and remove
the metal cover to avoid physical
injury.
This system comes with three 5.25-inch drive
bays located on the upper front section of the
chassis.
If your system came with an optical
drive, the optical drive occupies the
topmost bay (1). The lower bays (2
and 3) are available for additional
5.25-inch optical, zip, or floppy disk
drives.
Bay locks
Screw driver
Metal cover