User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Introduction to the BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Advanced menu
- 4.5.1 Platform Misc Configuration
- 4.5.2 CPU Configuration
- 4.5.3 System Agent (SA) Configuration
- 4.5.4 PCH Configuration
- 4.5.5 PCH Storage Configuration
- 4.5.6 PCH-FW Configuration
- 4.5.7 AMT Configuration
- 4.5.8 Thunderbolt(TM) Configuration
- 4.5.9 Serial Port Console Redirection
- 4.5.10 Intel TXT Information
- 4.5.11 PCI Subsystem Settings
- 4.5.12 USB Configuration
- 4.5.13 Network Stack Configuration
- 4.5.14 NVMe Configuration
- 4.5.15 HDD/SSD SMART Information
- 4.5.16 APM Configuration
- 4.5.17 Onboard Devices Configuration
- 4.5.18 Intel(R) Rapid Storage Technology
- 4.6 Monitor menu
- 4.7 Boot menu
- 4.8 Tool menu
- 4.9 Exit menu
- 4.10 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
ASUS E500 G9
4-13
Administrator Password
If you have set an administrator password, we recommend that you enter the administrator
password for accessing the system. Otherwise, you might be able to see or change only
selected fields in the BIOS setup program.
To set an administrator password:
1. Select the Administrator Password item and press <Enter>.
2. From the Create New Password box, key in a password, then press <Enter>.
3. Re-type to confirm the password then select OK.
To change an administrator password:
1. Select the Administrator Password item and press <Enter>.
2. From the Enter Current Password box, key in the current password, then press
<Enter>.
3. From the Create New Password box, key in a new password, then press <Enter>.
4. Re-type to confirm the password then select OK.
To clear the administrator password, follow the same steps as in changing an administrator
password, but leave other fields blank then select OK to continue. After you clear the
password, the Administrator Password item on top of the screen shows [Not Installed].
User Password
If you have set a user password, you must enter the user password for accessing the system.
The User Password item on top of the screen shows the default [Not Installed]. After you set
a password, this item shows [Installed].
To set a user password:
1. Select the User Password item and press <Enter>.
2. From the Create New Password box, key in a password, then press <Enter>.
3. Re-type to confirm the password then select OK.
To change a user password:
1. Select the User Password item and press <Enter>.
2. From the Enter Current Password box, key in the current password, then press
<Enter>.
3. From the Create New Password box, key in a new password, then press <Enter>.
4. Re-type to confirm the password then select OK.
To clear the user password, follow the same steps as in changing a user password, but
leave other fields blank then select OK to continue. After you clear the password, the User
Password item on top of the screen shows [Not Installed].