User Manual

4-36
Chapter 4: BIOS Setup
USB power delivery in Soft Off state (S5)
Allows you to enable or disable USB power when your PC is in the S5 state.
Configuration options: [Disabled] [Enabled]
Onboard LED
Allows you to turn on or off the HDD and PLED LEDs.
Configuration options: [Disabled] [Enabled]
USB1 Type C Power Mode
[Auto] Power will be provided to USB 3.2 Gen 2 Type-C ports automatically when
a device is detected.
[Enabled] Power will always be on for USB 3.2 Gen 2 Type-C ports.
Improper connection may damage the system permanently.
GNA Device
Allows you to enable or disable SA GNA Device.
Configuration options: [Enabled] [Disabled]
Serial Port Configuration
This submenu allows you to set parameters for Serial Port.
This item will only function if there is a serial port (COM) connector on your motherboard.
Serial Port
Allows you to enable or disable the Serial port.
Configuration options: [Enabled] [Disabled]
The following item appears only when Serial Port is set to
[Enabled]
.
Change settings
Allows you to select an optimal setting for super IO device.
Configuration options: [IO=3F8h; IRQ=4] [IO=2F8h; IRQ=3] [IO=3E8h; IRQ=4]
[IO=2E8h; IRQ=3]
Parallel Port Configuration
This submenu allows you to set parameters for Parallel Port (LPT/LPTE).
Parallel Port
Allows you to enable or disable Parallel Port (LPT/LPTE).
Configuration options: [Disabled] [Enabled]
Change settings
Allows you to select an optimal setting for super IO device.
Configuration options: [IO=378h; IRQ=5] [IO=378h; IRQ=5,6,7,9,10,11,12] [IO=278h;
IRQ=5,6,7,9,10,11,12]