User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Introduction to the BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Advanced menu
- 4.5.1 Platform Misc Configuration
- 4.5.2 CPU Configuration
- 4.5.3 System Agent (SA) Configuration
- 4.5.4 PCH Configuration
- 4.5.5 PCH Storage Configuration
- 4.5.6 PCH-FW Configuration
- 4.5.7 AMT Configuration
- 4.5.8 Thunderbolt(TM) Configuration
- 4.5.9 Serial Port Console Redirection
- 4.5.10 Intel TXT Information
- 4.5.11 PCI Subsystem Settings
- 4.5.12 USB Configuration
- 4.5.13 Network Stack Configuration
- 4.5.14 NVMe Configuration
- 4.5.15 HDD/SSD SMART Information
- 4.5.16 APM Configuration
- 4.5.17 Onboard Devices Configuration
- 4.5.18 Intel(R) Rapid Storage Technology
- 4.6 Monitor menu
- 4.7 Boot menu
- 4.8 Tool menu
- 4.9 Exit menu
- 4.10 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
ASUS E500 G9
4-27
4.5.8 Thunderbolt(TM) Configuration
The items in this menu allow you to configure Thunderbolt settings.
PCIE Tunneling over USB4
Allows you to enable or disable PCIE Tunneling over USB4.
Configuration options: [Disabled] [Enabled]
Discrete Thunderbolt(TM) Support
Allows you to enable or disable Discrete Thunderbolt(TM) Support.
Configuration options: [Disabled] [Enabled]
• Please set
Control Iommu Pre-boot Behavior
in the
System Agent(SA)
Configuration
page to
[Enabled]
to support DMA Protection Feature.
• The following items appear only when
Discrete
Thunderbolt(TM) Support
is set to
[Enabled]
.
Wake From Thunderbolt(TM) Devices
Allows you to enable or disable system wake from Thunderbolt(TM) devices.
Configuration options: [Disabled] [Enabled]
Discrete Thunderbolt(TM) Configuration
The items in this submenu allow you to configure Discrete Thunderbolt(TM) related
configurations.
DTBT Go2Sx Command
Allows you to enable the command to put DTBT into Sx state while system is going into
Sx.
Configuration options: [Disabled] [Enabled]
Windows 10 Thunderbolt Support
Allows you to specify Windows 10 Thunderbolt support level.
[Enable + RTD3] OS Native support plus RTD3.
[Disabled] No OS native support.
DTBT Controller 0 Configuration
DTBT Contorller 0
Configuration options: [Disabled] [Enabled]
TBT Host Router
Allows you to enable host router based on ports available.
Configuration options: [One Port] [Two Port]