User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Ai Tweaker menu
- 4.6 Advanced menu
- 4.6.1 Platform Misc Configuration
- 4.6.2 CPU Configuration
- 4.6.3 System Agent (SA) Configuration
- 4.6.4 PCH Configuration
- 4.6.5 PCH Storage Configuration
- 4.6.6 PCH-FW Configuration
- 4.6.7 AMT Configuration
- 4.6.8 Thunderbolt(TM) Configuration
- 4.6.9 Serial Port Console Redirection
- 4.6.10 Intel TXT Information
- 4.6.11 PCI Subsystem Settings
- 4.6.12 USB Configuration
- 4.6.13 Network Stack Configuration
- 4.6.14 NVMe Configuration
- 4.6.15 HDD/SSD SMART Information
- 4.6.16 APM Configuration
- 4.6.17 Onboard Devices Configuration
- 4.6.18 Intel(R) Rapid Storage Technology
- 4.7 Monitor menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Exit menu
- 4.11 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
4-48
Chapter 4: BIOS Setup
4.6.6 PCH-FW Configuration
The items in this menu allows you to configure the firmware TPM.
PTT
Allows you to enable or disable PTT in SkuMgr.
Configuration options: [Disable] [Enable]
Extend CSME Measurement to TPM-PCR
Allows you to enable or disable Extend CSME Measurements to TPM-PCR[0] and AMR
Config to TPM-PCR[1].
Configuration options: [Disabled] [Enabled]
The following items appear only when
SATA Controller(s)
is set to
[Enabled]
.
Aggressive LPM support
Allows PCH to aggressively enter link power state.
Configuration options: [Disabled] [Enabled]
SMART Self Test
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power-on Self Test) when an error occurs in the
hard disks.
Configuration options: [Disabled] [Enabled]
SATA6G_1 - SATA6G_8
Allows you to enable or disable the selected SATA port.
Configuration options: [Disabled] [Enabled]
SATA6G_1 - SATA6G_8 Hot Plug
Designates this port as Hot Pluggable.
Configuration options: [Disabled] [Enabled]