User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Ai Tweaker menu
- 4.6 Advanced menu
- 4.6.1 Platform Misc Configuration
- 4.6.2 CPU Configuration
- 4.6.3 System Agent (SA) Configuration
- 4.6.4 PCH Configuration
- 4.6.5 PCH Storage Configuration
- 4.6.6 PCH-FW Configuration
- 4.6.7 AMT Configuration
- 4.6.8 Thunderbolt(TM) Configuration
- 4.6.9 Serial Port Console Redirection
- 4.6.10 Intel TXT Information
- 4.6.11 PCI Subsystem Settings
- 4.6.12 USB Configuration
- 4.6.13 Network Stack Configuration
- 4.6.14 NVMe Configuration
- 4.6.15 HDD/SSD SMART Information
- 4.6.16 APM Configuration
- 4.6.17 Onboard Devices Configuration
- 4.6.18 Intel(R) Rapid Storage Technology
- 4.7 Monitor menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Exit menu
- 4.11 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
ASUS E500 G9
4-57
USB Single Port Control
Allows you to enable or disable the individual USB ports.
Refer to section
Rear panel features
in your motherboard’s user manual for the location of
the USB ports.
4.6.13 Network Stack Configuration
The items in this menu allow you to change the Network Stack Configuration.
Network stack
Allows you to disable or enable the UEFI network stack.
Configuration options: [Disable] [Enable]
The following items appear only when
Network Stack
is set to
[Enabled]
.
Ipv4/Ipv6 PXE Support
Allows you to enable or disable the Ipv4/Ipv6 PXE wake event.
Configuration options: [Disabled] [Enabled]
4.6.14 NVMe Configuration
This menu displays the NVMe controller and Drive information of the connected devices. You
may press <Enter> on a connected NVMe device which appears in this menu to view more
information on the NVMe device.