User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Ai Tweaker menu
- 4.6 Advanced menu
- 4.6.1 Platform Misc Configuration
- 4.6.2 CPU Configuration
- 4.6.3 System Agent (SA) Configuration
- 4.6.4 PCH Configuration
- 4.6.5 PCH Storage Configuration
- 4.6.6 PCH-FW Configuration
- 4.6.7 AMT Configuration
- 4.6.8 Thunderbolt(TM) Configuration
- 4.6.9 Serial Port Console Redirection
- 4.6.10 Intel TXT Information
- 4.6.11 PCI Subsystem Settings
- 4.6.12 USB Configuration
- 4.6.13 Network Stack Configuration
- 4.6.14 NVMe Configuration
- 4.6.15 HDD/SSD SMART Information
- 4.6.16 APM Configuration
- 4.6.17 Onboard Devices Configuration
- 4.6.18 Intel(R) Rapid Storage Technology
- 4.7 Monitor menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Exit menu
- 4.11 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
2-15
ASUS E500 G9
2.7 Hard disk drives (HDD)
The server system supports three (3) 3.5-inch Serial ATA hard disk drives via the hard disk
drive bays and one 2.5-inch HDD/SSD drive at the bottom of the HDD cage.
Installing 3.5-inch HDDs
To install 3.5-inch Serial ATA hard disk drives:
1. Remove the side cover of the chassis. Refer to the
Removing the side cover
section
for more information.
2. Prepare the 3.5-inch HDD and the bundled set of screws.
3. Locate the HDD cage lock, press it up (A), then swing the HDD cage outwards (B) until
it clicks in place.
4. Align and insert the 3.5-inch HDD into
the drive bay ensuring that the screw
holes on the HDD matches the screw
holes on the HDD cage.
Screw holes (HDD)
HDD cage lock
HDD cage
Screw hole (HDD cage)