User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Ai Tweaker menu
- 4.6 Advanced menu
- 4.6.1 Platform Misc Configuration
- 4.6.2 CPU Configuration
- 4.6.3 System Agent (SA) Configuration
- 4.6.4 PCH Configuration
- 4.6.5 PCH Storage Configuration
- 4.6.6 PCH-FW Configuration
- 4.6.7 AMT Configuration
- 4.6.8 Thunderbolt(TM) Configuration
- 4.6.9 Serial Port Console Redirection
- 4.6.10 Intel TXT Information
- 4.6.11 PCI Subsystem Settings
- 4.6.12 USB Configuration
- 4.6.13 Network Stack Configuration
- 4.6.14 NVMe Configuration
- 4.6.15 HDD/SSD SMART Information
- 4.6.16 APM Configuration
- 4.6.17 Onboard Devices Configuration
- 4.6.18 Intel(R) Rapid Storage Technology
- 4.7 Monitor menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Exit menu
- 4.11 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
Chapter 2: Hardware Setup
2-26
2.9 System fan
This section describes how to remove the system fan in the event that you need to install or
remove previously installed or new system components, or when the system fan needs to be
replaced because it was damaged or became defective.
To remove the system fan:
1. Disconnect the system fan cable from
the CHA_FAN1 connector on the
motherboard.
3. Remove the system fan.
2. Remove the four system fan screws at
the rear panel. Keep the screws for later
use.
Hold the system fan with one hand
while removing the system fan
screws.
Follow the previous instructions in
reverse order if you want to reinstall
the system fan.