User Manual

Chapter 2: Hardware Setup
2-28
For more BIOS update utilities in BIOS setup, refer to the section Updating BIOS in
Chapter 4.
5. Wait until the light goes out, indicating that the BIOS updating process is completed.
Refer to section Onboard LEDs for more information of the FlashBack™ LED.
• Do not unplug portable disk, power system, or short the CLRTC header while BIOS
update is ongoing, otherwise update will be interrupted. In case of interruption, please
press and hold the BIOS_FLBK button for 3 seconds again to restart the process.
• Ifthelightashesforvesecondsandturnsintoasolidlight,thismeansthatthe
BIOS FlashBack™ is not operating properly. Please check the following when this
happens:
- The USB drive should only contain a single partition.
 - TheUSBdriveshouldbeformattedtoaFAT32,FAT16,orNTFSlesystem.
 - TheBIOSlenameshouldbecorrectlynamed,andintherootfolderoftheUSB
drive.
- If the problem persists, the USB drive may not be compatible, please try another
USB drive of a different brand/model.
Then retry the flashback by pressing the BIOS FlashBack™ button for three seconds
until the FlashBack™ LED starts to blink
.