User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Ai Tweaker menu
- 4.6 Advanced menu
- 4.6.1 Platform Misc Configuration
- 4.6.2 CPU Configuration
- 4.6.3 System Agent (SA) Configuration
- 4.6.4 PCH Configuration
- 4.6.5 PCH Storage Configuration
- 4.6.6 PCH-FW Configuration
- 4.6.7 AMT Configuration
- 4.6.8 Thunderbolt(TM) Configuration
- 4.6.9 Serial Port Console Redirection
- 4.6.10 Intel TXT Information
- 4.6.11 PCI Subsystem Settings
- 4.6.12 USB Configuration
- 4.6.13 Network Stack Configuration
- 4.6.14 NVMe Configuration
- 4.6.15 HDD/SSD SMART Information
- 4.6.16 APM Configuration
- 4.6.17 Onboard Devices Configuration
- 4.6.18 Intel(R) Rapid Storage Technology
- 4.7 Monitor menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Exit menu
- 4.11 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
ASUS E500 G9
4-17
DRAM RAS# to CAS# Delay
Configuration options: [Auto] [0] - [255]
DRAM RAS# PRE Time
Configuration options: [Auto] [0] - [255]
DRAM RAS# ACT Time
Configuration options: [Auto] [1] - [511]
DRAM Command Rate
Configuration options: [Auto] [1N] [2N] [3N] [N:1]
The following item appears only when
DRAM Command Rate
is set to
[N:1]
.
N to 1 ratio
Number of bubbles between each valid command cycle.
Configurations: [1] - [7]
Secondary Timings
DRAM RAS# to RAS# Delay L
Configuration options: [Auto] [1] - [63]
DRAM RAS# to RAS# Delay S
Configuration options: [Auto] [1] - [127]
DRAM REF Cycle Time
Configuration options: [Auto] [1] - [65535]
DRAM REF Cycle Time 2
Configuration options: [Auto] [1] - [65535]
DRAM REF Cycle Time Same Bank
Configuration options: [Auto] [1] - [2047]
DRAM Refresh Interval
Configuration options: [Auto] [1] - [262143]
DRAM WRITE Recovery Time
Configuration options: [Auto] [1] - [234]
DRAM READ to PRE Time
Configuration options: [Auto] [1] - [255]
DRAM FOUR ACT WIN Time
Configuration options: [Auto] [1] - [511]
DRAM WRITE to READ Delay
Configuration options: [Auto] [1] - [15]
DRAM WRITE to READ Delay L
Configuration options: [Auto] [1] - [15]
DRAM WRITE to READ Delay S
Configuration options: [Auto] [1] - [15]
DRAM CKE Minimum Pulse Width
Configuration options: [Auto] [0] - [127]