Instruction Manual

36 Notebook PC User’s Manual
IV. BIOS Software
Main Sub-Menu
IDE Primary Master
This field is used to configure the IDE Hard Disk installed in the system. To configure a hard disk drive, move the cursor
to highlight the IDE Primary Master field and press the Enter key to enter the sub-menu.
Item Specific Help
IDE Primary Master [3242MB]
PhoenixBIOS Setup Utility
F1 Help Select Item Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select Sub-Menu F10 Save and Exit
Main Advanced Security Power Boot Exit
Auto = autotypes
hard-disk drive
installed here.
None = force setting no
IDE device.
CD-ROM = a CD-ROM drive
is installed here.
User = you enter
parameters of hard-disk
drive installed at this
connection.
Type: [Auto]
Cylinders: [ 6282]
Heads [ 16]
Sectors: [63]
Maximum Capacity: 3242MB
Multi-Sector Transfers: [16 Sectors]
LBA Mode Control: [Enabled]
32 Bit I/O: [Enabled]
Transfer Mode: [Fast PIO 4]
Ultra DMA Mode: [Disabled]
NOTE! Before attempting to configure a hard disk drive, make sure you have the configuration information supplied
by the manufacturer of the drive. Incorrect settings may cause your system to not recognize the installed hard disk. To
allow the BIOS to detect the drive type automatically, select [AUTO].