User’s Manual
Table Of Contents
- 本マニュアルについて
- Chapter 1: ハードウェアのセットアップ
- Chapter 2: 本機を使用する
- Chapter 3: Windowsを使用する
- Chapter 4: Power-On Self-Test(POST)
- Chapter 5: FAQとヒント
- 付録
- Federal Communications Commission Interference Statement
- FCC RF Exposure Information
- UL Safety Notices
- Power Safety Requirement
- TV Notices
- Macrovision Corporation Product Notice
- 聴覚障害を防ぐため
- Nordic Lithium Cautions(for lithium-ion batteries)
- Declaration of Compliance for Product Environmental Regulation
- EU REACH and Article 33
- EU RoHS
- Japan JIS-C-0950 Material Declarations
- 筐体のコーティングについて
- 回収とリサイクルについて
- 日本国内での無線周波数帯のご利用について
- Ecodesign Directive
- ENERGY STAR® Qualified Product
- EPEAT Registered Products
- Simplified EU Declaration of Conformity
- Federal Communications Commission Interference Statement
90 ノートPC ユーザーマニュアル
Federal Communications Commission Interference
Statement
This device complies with FCC Rules Part 15.Operation is subject to the following
two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to Part 15 of the Federal Communications Commission
(FCC) rules.These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio
communications.However, there is no guarantee that interference will not occur in
a particular installation.If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING! The use of a shielded-type power cord is required in order to meet
FCC emission limits and to prevent interference to the nearby radio and television
reception.It is essential that only the supplied power cord be used.Use only shielded
cables to connect I/O devices to this equipment.You are cautioned that changes or
modications not expressly approved by the party responsible for compliance could
void your authority to operate the equipment.
(Reprinted from the Code of Federal Regulations #47, part 15.193, 1993.
Washington DC: Oce of the Federal Register, National Archives and Records
Administration, U.S. Government Printing Oce.)