E18692 Upgrade Guide Removing the compartment cover NOTE: The appearance of your Notebook PC’s bottom view may vary per model. A. Remove the screw(s) from the Notebook PC’s compartment cover. B. Loosen the Pop-open Screw without removing the screw from the cover. C. Pull out the compartment cover and remove it completely from your Notebook PC.
To reattach the compartment cover: A. Align and reattach the cover of the compartment. B. Secure the cover using the screw(s) you removed earlier. C. Tighten the Pop-open Screw.
Cover screw map 15” model M2.5 X 12L (2PCS) M2.5 X 9.5L (8PCS) M2.5 X 8L (1PC) M2.
17” model M2.5 X 13L (2PCS) M2.5 X 10L (4PCS) M2.5 X 8L (5PC) M2.
Disconnecting the battery A. Remove the compartment cover. NOTE: For more details, refer to the Removing the compartment cover section in this manual. B. Disconnect the cable from the battery connector. NOTE: The illustration is for reference only. To connect the battery, align and connect the cable to the battery connector before you reattach the compartment cover.
Installing a RAM module Upgrade the memory capacity of your Notebook PC by installing a RAM (Random Access Memory) module in the memory module compartment. The following steps show you how to install a RAM module into your Notebook PC: WARNING! Disconnect all the connected peripherals, any telephone or telecommunication lines and power connector (such as external power supply, battery pack, etc.) before removing the compartment cover.
A. Remove the compartment cover. NOTE: For more details, refer to the Removing the compartment cover and Disconnecting the battery sections in this manual. B. Align and insert the RAM module into the RAM module slot. C. Push down the RAM module until it clicks in place.
Installing an M.2 card Refer to the following steps when installing a compatible M.2 card in your Notebook PC: IMPORTANT! Purchase your M.2 card from authorized retailers of this Notebook PC to ensure maximum compatibility and reliability. WARNING! Disconnect all the connected peripherals, any telephone or telecommunication lines and power connector (such as external power supply, battery pack, etc.) before removing the compartment cover.
A. Remove the compartment cover. NOTE: For more details, refer to the Removing the compartment cover and Disconnecting the battery sections in this manual. B. (optional) Insert the M.2 card into the wrap in the orientation shown in the illustration below. C. Align and insert the M.2 card into the module slot. D. Secure the M.2 card in place using the bundled screw(s).
Notebook PC Upgrade Guide
